This brilliant idea is incredibly simple. It makes a great gift and is easy on the bank.
The Nice and Neat Manicure Kit holds all the tools one could need to keep those nails looking fine.Folding up nice and compact to be taken along with you, making this design pretty basic, it's the perfect launch pad to take the design and really make it your own. Let's take a look!
(Folded) 7 1/2" x 5 1/4"
(Unfolded) 7 1/2" x 13 1/2"
4 gorgeous fat quarters from
Water Soluble Pen
Cut two 13 1/2" x 7 1/2" rectangles (1 print each)
Cut two 2" x 10" strips (1 print)
Cut one 2 1/2" x 42" bias strip (1
INSTRUCTIONS (Note: 1/4" seam allowance unless otherwise stated.)
Following the manufacturer's instructions fuse fleece to the wrong side of the 13 1/2" x 7 1/2" rectangles.
Using a spool of thread or a similiar round object mark two rounded corners with a water soluble pen or pencil. Trim the corners. Set aside.
Take one 2" x 10" strip and fold in half lengthwise right sides together. Stitch along the raw edge.
Repeat with the remaining 2" x 10" strip.
Using a loop turner, turn the strips inside out and press.
Pin one strip about 5 3/4" down from the top of the right side of the 13 1/2" x 7 1/2" rectangle you plan to use as the inner panel.
This next step will depend upon which tools you plan to put in your kit. Place the tools underneath the strip and make a mark on either side of the tools with a water soluble pen or a pencil. Using a backstitch at the beginning and end, stitch a small line over the marks you just made.
Repeat the previous steps for the bulkier tools with the remaining strip. This time pinning about 3 inches from the bottom of the inner panel, leaving a bit of ease for the tool to slip underneath the strip. Don't forget to remove the pins!
Next, take the 'male' magnetic snap and make a mark with the prongs about an inch from the top of the inner panel in the center. Take your seam ripper and gently cut the two marks you just made.
Slip the prongs through the holes.
Flip the inner panel over, slip the back of the snap over the prongs and flatten them. You can just use your fingers if you're feeling like Superman or a pair of pliers.
Repeat the previous steps with the 'female' part of the snap on the bottom of the outer panel about 1 3/4" from the bottom. Snaps are done!
Place the two 13 1/2" x 7 1/2" panels wrong sides together. You can hand baste these two panels together OR to make this project even quicker, just spray the wrong side of one of the panels with Heat and Bond Basting Adhesive. Then place stick the two panels together. I prefer this method because it's not only quick, but it will keep the panels from shifting when you fold them up.
Finally, bind the kit with the bias tape starting at the center bottom. This way you can make one mitered corner, THEN the curves, and finish off with the last mitered corner.
Be sure to carefully pin the curves as you go.
Add your tools and voila! A happy little manicure kit! Enjoy!